Reply To: It may need to be initialized

#5609

twinblown
Member

It may need to be initialized as follows

Initialization Mode
Initialization mode is used to set the default values of door full open position and normal motor current.
It is necessary to complete initialization and reset the default settings under any of the following circumstances:
Sliding door control unit is replaced.
Sliding door motor is replaced.
Sliding door is adjusted.
Sliding door panel is replaced or repaired.
Body panel near sliding door is replaced or repaired.
Any sliding door roller is replaced or adjusted.
Any sliding door striker is replaced or adjusted.
Any sliding door dovetail is replaced or adjusted.
Sliding door lock assembly is replaced.
Rear rail is replaced.
Sliding door weatherstrip is replaced.
Sliding door contact switch is replaced or adjusted.
When the battery is first connected, the sliding door control unit is automatically set to the initialization mode.
The sliding door control unit may be manually set to initialization mode by performing the following procedure:
SLIDING DOOR INITIALIZATION PROCEDURE
NOTE:
While in initialization mode, only the overhead sliding door open/close switches are enabled. Remote keyless
entry, door pillar switch and power assist functions are disabled. Each of the power sliding doors must be initialized individually. The following procedure can be repeated for each power sliding door needing initialization.
1. Open the sliding door being initialized.
2. Turn ignition switch ON.
3. Turn the Automatic Door Main Switch OFF.
4. Within 3 seconds after step 3, press the door pillar Sliding Door
Open/Close Switch of the door being initialized 10 times within
10 seconds.
5. Within 3 seconds after step 4, turn ignition switch OFF then ON.
You should hear three sliding door warning chimes.
The three chimes indicate the sliding door control unit has entered initialization mode. Normal door functions are disabled during initialization.
6. Turn the Automatic Door Main Switch ON.
7. Press and HOLD the overhead Sliding Door Open/Close Switch
of the door being initialized until the door completely closes and
stops, then release the switch.
8. Press and HOLD the same overhead Sliding Door Open/Close Switch of the door being initialized again
until the door completely opens and stops, then release the switch.
9. Press and HOLD the same overhead Sliding Door Open/Close Switch of the door being initialized again
until the door completely closes and stops, then release the switch.
10. Turn ignition switch OFF.
The power sliding door initialization process is complete. The above procedure may be repeated for the other
power sliding door (if equipped).