SES and VDC OFF Light on & Loses power and Goes Into Limp Mode

New Topics Forums General Discussion 2004 – 2009 Nissan Quest SES and VDC OFF Light on & Loses power and Goes Into Limp Mode

This topic contains 0 replies, has 1 voice, and was last updated by  iLlMaTiC21390 6 years, 7 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #1297

    5 Months ago my SES and VDC off like came on and the van went into limp mode and wouldn’t rev past like 2000 RPM or something or that range and the van loss power. The transmission would also clunk in between changing gears like from park to drive and reverse. If you restart the van it starts acting normal again until it begins to act bad again. 5 months later my van is still at the dealer cause they can’t fix the problem and don’t know whats going on. They even changed the camshaft and crank sensors per the code that came up with the SES and VDC off light. They changed those sensors and the van is still acting the same way. They even changed the transmission and engine computer and that didn’t fix it either.

    I’m a little puzzled on what’s going on. Can anyone help?

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.